The Korean engineers turned the machines off, cut the power wires, and loaded them into the truck, with the two Koreans arguing with each other in Korean the entire time.
The acting boss of the company was a 32-year-old guy, the big boss being out of the country. He said all the engineers were imported from Korea. Curious, I asked what the salary was for a Korean brought in, and he told me it was about 5,600 USD a month. Not too shabby for 40 hours a week.
I also observed that almost all the staff, other than the engineers and some muscle-type work, were females. Most of them were young and pretty. The company has a dorm for the workers there, and there was a long parade of pretty girls walking by to their dorm as we were loading the truck.
I joked with the boss there that I could not work in a place like his; it was too much opportunity to get into trouble.
Delivery, after a lot of swearing and shouting at my shop, we forklifted everything off the truck. I should have booked two smaller trucks versus one big truck. Learned my lesson there. It would have gone a lot smoother. I would have had a lot more room to move the forklift around and they would have not torn up my driveway so badly.
I also discovered that the new machines have built-in inverters that can run on single-phase power. So basically I can connect and run. I was planning intially of swapping to single phase motors. This is going to save me well over a thousand dollars.
One machine has 10 hp, which is what I run now; the other is 15 hp, which is too big for my power supply unless I underdrive it, keeping the motor load at 40–45 amps or less. Once I upgrade to some grid-tie solar, I can push it to the max.
The 10 hp I sold for enough to pay for both machines. Plus I kept the cooling line and conveyor. So I’ll pull the metal covers off, repaint, shine up the stainless steel, and it will look like new. It will stay in my shop for the time being to be operated by a client until she arranges her own factory space next year.
2 comments:
That's a whole lot smaller than the extruders I learned to run when I worked for a vinyl siding manufacturer. They had large twin screw Krauss Maffei extruders. Ten of them. The largest was producing about 400 lbs of siding per minute. You worked your butt off if you were one of the two inspector/packers on that line.
I have available a full factory to rent with equipment that can run big amounts daily. But it would cost roughly 200kusd to turn it on plus a operating reserve, marketing budget, etc. Could not pull off the finding for it, so it was wasted time. This one I control everything, answer to no investor. Have no real debt.
Post a Comment